Basalt Plug

For a volcanic eruption to occur, magma must make its way up to the surface, which implies there must be conduits through the rock below. Usually these conduits aren't exposed. They're either covered by the erupted lava, or, if erosion has removed the lava, are so small relative to the size of the erupted material that they're likely to have been eroded away too. In any case, they are easily missed. But not far from Mono Lake, there is an unusual case where the "pipe" that fed an eruption at the surface is both exposed and readily recognizable.

This so-called "plug" is composed of dark basalt, which contrasts strikingly with the surrounding light granite. Up close, the basalt can be seen to be full of granite fragments broken out of the surrounding rock. They are typically rounded; not only was the molten basalt above the melting point of the granite but it is out of chemical equilibrium with it, so the edges of the granite fragments were not just melting, but dissolving.

Based on its age and chemical composition, this plug is thought to have been the feeder for basalts that are now exposed along US-395 a couple of miles north of Conway Summit and some 600 feet higher. This height gives an estimate of how much erosion has taken place. The plug may well have fed a cinder cone on the surface, as those are a typical result of small basalt eruptions, but it has long since eroded away.